New Page 0

You have now provided your experienced and Inexperienced drivers with the BEST tool available.

Forklift Safety Device
ACCU-FORK / TINE- GUIDE

Laser Guided Forklift System
Mounting and Servicing Instructions

For self-contained units

1. Remove ACCU-FORK / TINE-GUIDE from the package.

2. Decide where you want to mount it on the forklift carriage. (Left, Right, or Center).

3. Hook the bottom of the
ACCU-FORK/ TINE-GUIDE to the bottom of the carriage and the top up flush against the carriage.

4. Using the allen wrench, tighten the two bolts down against the groove on the back side of the carriage.

Illustration #1

Illustration #2

5. Remove battery pack from package and insert into housing with the plug in the upright position.

6. Plug the battery pack in using the plug on the battery pack and the plug hanging inside the housing.

(Laser should come on and stay on a couple minute, this allows the laser to reset itself.)

7. Attach the Velcro cover to the other side.

8. The laser will come on when movement occurs and go out about 4 minutes after movement stops.

Aligning ACCU-FORK / TINE GUIDE

1. Lay something flat across the tips of the forks for adjusting laser height.

2. The laser light should be adjusted until it shoots just under the edge of the box, thus being in alignment with the tips of the tines.

3. Use the supplied allen wrench to adjust the set screw (on the bottom of the ACCU-FORK housing).

Re-Charging ACCU-FORK/ TINE-GUIDE Battery

                                                        1. Remove battery cover from the ACCU-FORK housing.
                                                        2. Unplug battery and remove it from the unit.
                                                        3. Connect battery to appropriate plug on the charging unit.
                                                        4. Connect the plug from transformer to the other plug on the charging unit.
                                                        5. Plug transformer into an 110VAC outlet. (Overseas Customers must use the
                                                        appropriate transformer for their electrical current requirements).
                                                        6. The LED should start blinking. After a brief period, the LED will remain solid.
                                                        7. 80% Charge time is approximately 4 hours.

8. The charger will trickle charge the battery to full charge after

                                                        about 4 additional hours.
                                                        9. Disconnect the transformer from the outlet.
                                                        10. Disconnect the battery from the charging unit.
                                                        11. Replace battery in the ACCU-FORK housing
                                                        12. Reconnect battery.

Note: Charging of the battery pack should be done in a cool,
dry area with adequate ventilation.
This helps increase the life of the batteries.

US LASER, INC